AquaMaster S300 Pro 2 Substrate pH/Temp Meter

More details about AquaMaster S300 Pro 2 Substrate pH/Temp Meter:

• Connect the BNC connector of the electrode to the pH meter and remove the protective cap containing storage solution from the electrode
• Rinse the electrode with running water and dry it using clean kitchen paper
• Press the on/off button to turn on the meter
• Place the electrode in the (soft) substrate (make sure the substrate is well wet/damp, otherwise the meter will not work properly) or liquid to be measured
• Wait for the value to stabilise. The measurement is now complete
• Press the HOLD button to save the measurement. Do not forget to press the HOLD button again when the meter is used once more
• Rinse the electrode with clean water after use, so that no residue is left on the electrode. Replace the electrode in the protective cap containing the storage solution
• Press the on/off button to turn off the meter

• 1x Digital Substrate pH/Temp meter S300 Pro 2
• 1x User Manual

• Range: pH: 0.0 ~ 14.0 pH / Temp.: 0°C ~ 50°C (32°F ~ 122°F)
• Resolution: pH: ± 0.1 pH / Temp.: 0.1 ºC (1.0 ºF)
• Accuracy: pH: ± 0.1 pH / Temp.: ±0.5°C (32°F) / Temp. compensation: 0°C - 50°C (32°F - 122°F)
• Calibration: pH: 2 point auto 4.0 - 7.0 pH
• Features: Battery indicator & automatic temp. compensation
• Power supply: 3 × 1.5 Volt AG-13 button cell battery (included)
• Auto. power-off: After 8 minutes
• Calibration indicator: With correct calibration
• Waterproof: IP65 (electrodes are IP67 waterproof)
• Dimensions: 8.66" x 1.57" x 1.57"
• Weight: 0.35 lbs